EPOMIR PTG

CATEGORY MIROMIX
TINTING
SYSTEM		 TYPE ASPECT EFFECT APPLICATION HARDENING
    Antir.
Phosph.Zn		 Base Finish   Micaceous Metalized Embossed Hammered Iron Galvanized
LIGHT
ALLOYS 		Fibreglass
plastic 		Yes To
taste
Epoxy SI SI SI GLOSSY GLOSSY SI SI SI SI SI SI SI SI SI

 

EPOMIR PTG is an epoxy paint for the internal lining of pipes for gas transport. It resolves, once and for all, the always more serious problems regarding the emission of solvents in the atmosphere. Actually, EPOMIR PTG is a solvent-free paint product that has a solid in weight and therefore, with an equivalent thickness, has a performance that is almost the double per square metre compared to the traditional paints that contain solvents. During its application, no solvent vapour is created thus safeguarding the ecological impact and also the environment where painting staff operate.

EPOMIR PTG is a highly-viscose epoxy but its particular formula enables the internal coating of pipes of any type of diameter, with thicknesses even up to only 60 microns, without adding diluents.

After its application, EPOMIR PTG leaves a shiny, ultra smooth surface that reduces friction and turbulence increasing flow speed and guaranteeing protection from the pipe's internal corrosion before installation.

EPOMIR PTG has passed all technical, mechanical and chemical tests provided by the most important international regulations and specifications for the internal coating of gas pipes.

Approved by:

· API RP 5L2

· SNAM GASD C.09.11.01

· ISO 15741

· UNI EN 10301:2003

Complete Documentation

Utilization fields
Internal part of tubes for gas Transport
Specific weight
1.360 - 50 kg/m3 hardened product at 20°C
Solids in weight
98 +/- 2 % in weight (hardened product) / 96,5 +/- 2% in volume (hardened product)
Hardening
33% in weight with hardener Epomir RV9031 ( ratio in volume 2,5:1)
Thinning
----------------------------------------
Application viscosity
----------------------------------------
Pot-Life at 20°C
---------------------------------------
Drying
23°C +/-2°C AT TOUCH: Hours 4--5 COMPLETE HARDENING : 15 giorni
Theoretic Performance
28 square metres /kg
Colour
Red
Application method
product is ready for use. It needs to be applied with an airless bi-mix system endowed with pre-heater (both for Component A and Component B) reaching up to a temperature of at least 60º C and a compression ratio of at least 67:1. The nozzle and angle must be chosen according to the diameter of the pipe that needs to be coated
Application conditions
The product needs to be applied at an environment temperature higher than 8º C and lower than 40º C and in any case 3-4º C higher than dew temperature. The relative humidity must be lower than 85%
Surface preparation
The surface to be painted needs to be sanded to SA 2½ degree with a roughness between 30 and 50 microns (Rz DIN).
Storage
Six months in cool ventilated place
Hygienic and security regulations
During application, it is advisable to stay in well-ventilated environment and to use protective masks.
Warnings and specifications
A specific technical data sheet for each product is available on demand. This can be requested when placing the order.

The numbers in this data sheet are subject to normal variations related to production, application methods, atmospheric conditions, wet film thickness and structure complexity.

The company is not liable to any responsibility on results that can derive even from factors that do not depend on the quality of the products.

Data refer to the standards in force on the date in which they are printed. The company reserves itself the right to amend them without notice.
eZ publish™ copyright © 1999-2005 eZ systems as